Petsfang 3d Printing Technologies​

Installation instructions for

Petsfang E3D Titan Direct for Stock and MicroSwiss hot ends. 

How to adjust your duct vertically?

This is for all Petsfang Mods.  

Petsfang Titan Direct Installation E3Dv6

Installation instructions for

Petsfang E3D Titan Direct for E3Dv6 and Volcano hot ends. 

Petsfang Titan Direct Installation Stock Hot End

Duct opening should be just below the heat block's insulation. Approximately 1.5mm above the print bed.

"Where Ideas & Engineering Collide"

If you have questions please email me at davidpetsel@petsfang.com

​                                     Coralville, Iowa